REVOLVER - Mounting Instructions

It is recommended that you use a hand tool as drills can over tighten/strip screws.

1. After unpacking remove the center pin by pushing into the center of the base from the bottom of the device.

2. Mount the base using the 2 provided 3/4" screws, and 2 #6 washers. The washers go between the screws and the base, not the base and the surface you’re mounting to. DO NOT OVER TIGHTEN.

3. Place the REVOLVER body on the base and insert the center pin.

4. Finish by using the provided 1/2" screw and #6 washer to mount the center pin to your mounting surface.